Nautilus Quinton Owner's Manual - Console Codes
CONSOLE CODES
C
O
N
SO
LE
C
O
D
ES
Machine Status Codes
To view maintenance information such as the run
time in hours, number of workouts and distance,
as well a machine type and software revision:
1. Press [SPEED UP], [4], [ENTER]. The console
will display “MACHINE STATUS”.
2. Press [SPEED UP or DOWN] to scan through
the choices. Select the option you want to view
by pressing [ENTER]. Press [CLEAR] to exit the
machine status codes.
The machine status options are as follows:
Machine run time in hours
• Display the machine run time in hours.
The console will display “RUN HOURS #####”.
Number of workouts
• Display the number of times a workout key
has been pressed. The console will display
“WORKOUTS ####”.
Distance traveled
• Display the total distance traveled in miles
(or kms if console is set to Metric units) . The
console will display “DISTANCE #####”.
Software revision
• Display the console software revision number.
The console will display “CONS 41376-###”.
Machine type
• Display the machine type the console is
currently confi gured to. The console will
display “Quinton Fitness by Nautilus” or other
machine type.
TM Drive version
• Display the treadmill drive version. The
console will display “ # “
Machine run time in hours since last cleared (used
for maintenance)
• Display the machine run time since last
cleared. The console will display “MAINT
HOURS #####”. This will provide the number
of hours between service or maintenance calls.
The machine run time is reset to zero in the
following Diagnostics section.
3. To exit “MACHINE STATUS”, press the [CLEAR]
key.
Diagnostic Codes
Diagnostic codes are used to test various
components of the machine such as the
display, keyboard, serial port, alternator,
and tachometer, as well as viewing the
error log information and resetting the time
between service or maintenance calls. To run
diagnostics and view diagnostic information:
1. Press [SPEED UP], [6], [ENTER]. The console
will display “DIAGNOSTICS”.
2. Press [SPEED UP or DOWN] to scan through
the choices. Select the option you want to view
by pressing [ENTER].
The diagnostic options are as follows:
Test display
• To test the LCD display, press [ENTER] when
the message, “DISPLAY TEST” is displayed.
The console screen alternates turning on all
LCD segments and a representative program
screen. Verify that all LCD segments turn on.
N
A
U
TI
LU
S
®
49