Nautilus Quinton Owner's Manual - Turning On The Power

N

A

U

TI

LU

S

®

S

A

FE

TY

 R

EQ

U

IR

EM

EN

TS

®

C HA NG I N G  T H E   G A M E   I N   H EA LT H  A N D   F I T N E S S  

®

6

12. Install the four #10 screws and external star washers in the front of the 

hood cover to secure it to the power input plate. 

13. Install the two front-end caps (included) on the front ends of the treadmill 

frame (Figure 2). 

14. Verify that the voltage for the power source matches the voltage on the 

nameplate on the front of the treadmill hood, then plug in the power cord.

 15. To connect the treadmill to a computer, plug an RJ-45 telephone cable 

into the serial connector on the rear panel of the controller, then into the input 

connector on the computer. 

Turning On the Power

The circuit breaker on the front of the treadmill hood controls the power to 

the  treadmill.  The circuit breaker must be set to ON for the treadmill to run.

IMPORTANT

Turn off treadmill circuit breaker before 

connecting or disconnecting treadmill to outlet. 

Testing the Treadmill and Controller

1. Test all operational functions, including speed, grade, timer, heart rate 

control, intervals, parameters, all limit controls, and serial communication. 

 2. With the power switch set to ON and the console display at the opening 

message, "Nautilus Cardio",  press the Quick Start key.  Verify that the 

treadmill accelerates gradually to minimum speed. 

4. Press and hold the Incline Down key until the treadmill reaches zero grade. 

5. Press the Speed Up key until the treadmill is running at maximum speed and 

grade. 

6. Let the treadmill run for 15 minutes. 

7. Watch the walking belt carefully to ensure that it does not drift left or right. 

Listen for unusual noises, such as squeals or squeaks. 

8. Walk on the moving belt and verify proper operation at representative 

speeds and grades. If the walk belt slips, but the front roller turns, adjust the 

walk belt tension. 

9. Check operating limit controls (access, time, speed). 

10. Check menu displays and functionality. 

10. When the test is fi nished, 

INSTALLATION & OPERATION