Nautilus Quinton Owner's Manual - Installation & Operation
N
A
U
TI
LU
S
®
S
A
FE
TY
R
EQ
U
IR
EM
EN
TS
7
INSTALLATION & OPERATION
a. Press Incline Down Arrow until the treadmill is at zero grade.
b. Press Stop.
If the treadmill does not run smoothly, contact your Nautilus, Inc. sales
representative before using it.
Understanding the Display and Controls
The treadmill display is a computerized panel used to operate the treadmill and
see all workout data and operational status. You should familiarize yourself with
the operation of the treadmill and the location of all keys before beginning use.
Limited Access Control/Magnetic Safety Stop
Limited-access control lets you restrict treadmill use to authorized personnel.
It also lets you stop the treadmill in an emergency. The magnetically-activated
control is located on the bottom of the display as shown. The limited-access
control is deactivated on machines shipped from the factory.
Magnetic Safety Stop Activation
To activate the limited-access control and restrict access, place the magnetic
safety stop cord supplied with the treadmill in the designated area located
below the display.
The magnet will activate the control. If you remove the key, the treadmill belt will
stop and the controller will not respond to any key presses. Accumulated values
will remain on the display until you turn off the power, or press [Clear].
The console will display a message, REPLACE MAGNET when you remove the
magnetic key from its designated area. You must replace the key or deactivate
the control to start the walk belt.
Magnetic Safety Stop Deactivation
To deactivate the Safety Stop Cord and permit unrestricted access of the
treadmill follow the steps below.
1. With the magnet key in place and the display at the opening message,
SELECT WORKOUT, or, if the magnet key is removed and the display reads,
REPLACE MAGNET, press [Speed UP], [3], [ENTER]. The display will read
“CUSTOMIZE”. Use the [Speed UP] or [Speed DOWN] keys to scroll through
the options until the console displays ENABLE MAGKEY.
2. Press [ENTER], and the display will either read ON or OFF. Press [SPEED
+] or [SPEED -] to toggle between ON and OFF. With OFF displayed, press