Nautilus Quinton Owner's Manual - Receiving
N
A
U
TI
LU
S
®
S
A
FE
TY
R
EQ
U
IR
EM
EN
TS
®
C HA NG I N G T H E G A M E I N H EA LT H A N D F I T N E S S
®
4
Receiving
When the carrier delivers your order, verify that the number of items received
equals the number listed on the freight bill or express receipt.
Inspect the containers for damage. Itemize discrepancies and damage on the
waybill and have the agent sign it. Failure to describe external evidence of loss
adequately may result in the carrier refusing to honor your claim. Do not discard
the packing materials until you have verifi ed physical condition and proper
operation.
Installation Notice
The treadmill and controller must be installed correctly before being used.
Nautilus, Inc. recommends that you contact your treadmill dealer or sales
representative when your equipment arrives. The representative will help
unpack, install, and demonstrate it to ensure that:
• equipment is free from shipping damage.
• the treadmill is connected correctly to the appropriate AC power source.
• installation and operation are in accordance with Nautilus, Inc. standards.
Incorrect installation by unauthorized personnel can lead to equipment damage
and may void the warranty.
WARNING
The treadmill must be on a dedicated branch circuit.
No other device should be connected to that circuit.
Excessive risk current (leakage) can result if the equipment is not properly
grounded.
Failure to follow these guidelines will produce a serious or possibly fatal
electrical shock hazard. Consult a qualifi ed electrician as required.
Site Requirements
The treadmill requires a dedicated AC power line. To ensure electrical safety,
the treadmill is equipped with a three-wire power cord and three-pronged
plug. To maintain ground reliability, the plug must be connected to an equivalent
receptacle.
The treadmill is designed to operate in a typical fi tness environment with
adequate heat dissipation (1850 Watts maximum). Place the treadmill on a fl at
surface, free of moisture and debris. Maintain a minimum clearance of 1.5 feet
on each side and 6 feet at the rear.
INSTALLATION & OPERATION