Chapter 4: Operating System Recovery
4-3
3. Connect the DC Power Cable to the CD-ROM power connector and
an AC outlet.
4. Insert the CD that contains the operating system image in the CD-
ROM drive.
Software CD LPINs
7460 Model
Win2000
WinNT
Win98
Win95
DOS
7460-22xx
D370-0505-0100 D370-0496-0000 D370-0497-0100 D370-0498-0100 D370-0499-0100
5. Apply power to the terminal.
6. Press
F2
at the screen prompt to enter the Setup Utility.
7. In the
Advanced
menu, select
Multiple ROM Menu
.
8. Set the
Parallel CD-ROM Boot
to
Enabled
.
9. Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
10. Follow the DOS screen prompts. After each entry, you are asked to
confirm your input. You can use 1 or y for Yes, 2 or n for No.
11. Enter whether or not you want to perform
Disk Verification
.
(Answering Yes takes twice as long, but is recommended.)
If Yes is selected:
•
The Ghost software verifies write operations and handles bad
FAT clusters.
•
The Ghost error file (GHOST.ERR) is displayed before
rebooting