Chapter 5: BIOS Updating Procedures
5-3
6. In the
Advanced
menu, select
Multiple ROM Menu
.
7. Set the
Parallel CD-ROM Boot
to
Enabled
.
8. Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
9. Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
•
Automatic BIOS Update – update process runs unattended
Note:
You can see a prompt for terminal model and serial
number information. If the program detects invalid
information in the current BIOS, or if you are replacing the
processor board, there is not model/serial number information
in the BIOS.
Important:
Model/Serial Number is mandatory for FitClient
operation.
•
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note:
Model/Serial number data that is currently stored in the BIOS
is displayed during power up.
10. You should see a green window, indicating a successful update.
11. Press any key to reboot.
12. When the system reboots, press
F2
at the screen prompt to enter
Setup.
13. In the
Exit
menu, select
Load Setup Defaults
.
14. Go to the ADVANCED MENU and set RESET
CONFIGURATION DATA to [YES].
15. Exit Setup and Save Changes.