3-4
Chapter 3: BIOS Setup
Primary Master
After installing a new hard drive, the system should automatically
detect the drive. If this is not done automatically and you need to
configure the IDE Adapter. Perform the following steps:
1. Move the cursor to the Primary Master option and press Enter. A
sub-menu appears for the IDE drive.
Item Specific Help
Type:
[Auto]
LBA Format
Total Sectors:
8452080
Maximum Capacity
4327MB
Multi-Sector Transfers: [16 sectors]
LBA Mode Control:
[Enabled]
32 Bit I/O:
[Disabled]
Transfer Mode:
[Fast PIO 4]
Ultra DMA Mode:
[Mode 2]
2. Use the F5 and F6 keys to select the Type of hard disk. If Auto is
selected, the fields are automatically filled, based upon the installed
drive.
3. Move the cursor to the Exit menu, select Save Changes & Exit or Save
Changes, and press Enter.
Main
Exit
PhoenixBIOS Setup Utility