P&E Microcomputer Systems XPC560S EVB User Manual - page 17
of
69
xPC560S EVB User Manual
13
3.2
LEDs
There are four user LEDs available on the xPC56XXMB. All LEDs are active
low.
J7 – LEDs Enable
Controls whether the LEDs on the xPC56XXMB motherboard are connected
to I/O pins of the processor. The jumpers can be removed and wires can be
used to connect each LED to any processor I/O pin, if desired. Please note
that although the schematics indicate that the processor I/O pins are eMIOSx,
those are not the I/O pins for the xPC560S EVB. The table below has the
correct pins listed.
Figure 3-2: LEDs circuitry schematic
Jumper Setting
Effect
1+2 (default on)
LED1 connected to PE4
3+4 (default on)
LED2 connected to PE5
5+6 (default on)
LED3 connected to PE6
7+8 (default on)
LED4 connected to PE7