P&E Microcomputer Systems XPC560S EVB User Manual - page 23
of
69
xPC560S EVB User Manual
19
J20 – LIN2 master selection
J21 – LIN2 pin1 configuration
J29 – LIN2/SCI TxD selection
Controls whether the TxD pin on LIN2 or SCI is connected to the default I/O
pin on the MPC560xS processor.
Jumper Setting
Effect
On
LIN2 is configured as a master node
Off (default)
LIN2 is configured as a slave node
Jumper Setting
Effect
On
Pin 1 of the LIN2 connector is connected to 12V
Off (default)
Pin 1 of the LIN2 connector is not connected to 12V
Jumper Setting
Effect
1+2
The LIN2 TxD pin is connected to the “PI6” pin on the
MPC560xS processor. This should be set if enabling
LIN2.
2+3
The SCI TxD pin is connected to the “PI6” pin on the
MPC560xS processor.