P&E Microcomputer Systems XPC560S EVB User Manual - page 54
50
xPC560S EVB User Manual
6
xPC560SADPT208S HARDWARE & JUMPER SETTINGS
6.1
Boot Configuration
The following jumpers affect the operation of the processor as it initially
comes out of the reset state:
J7 – FABM Configuration
Controls whether the processor boots from internal FLASH or from a serial
interface (CAN, SCI)
J8 – ABS0 Configuration
If J7 is configured for serial boot mode, this jumper selects between UART or
CAN. If J7 is configured for internal boot mode, this jumper has no effect.
Jumper Setting
Effect
1+2
The MPC560xS processor uses serial boot mode
2+3 (default)
The MPC560xS processor uses internal boot mode
Jumper Setting
Effect
1+2
The MPC560xS processor uses the CAN interface for
serial boot mode
2+3 (default)
The MPC560xS processor uses the UART interface
for serial boot mode