Pocket Wizard MultiMAX Owner's Manual - Controls
1
ConTrols
Power Switch
TRANSMIT = Unit is powered on in TRANSMITTER (TX) mode
RECEIVE = Unit is powered on in RECEIVER (RX) mode
OFF = Unit is powered OFF
Keypad
A B C D L = Selects Quad-Triggering Zones and
Local. Also used in menu navigation and numeric entry
TEST = Triggers MultiMAX. Press to test operation or to
trigger remote units and/or attached cameras/flashes
Illuminates LCD and keypad. Hold down for key
lock. Pressing it while in any menu will bring you back
to the Main Screen.
/MENU = enters menus, and is used to enter or select items.
▲▼ Used for menu selection, selecting channels and numeric entry.
Port 1 / Port 2
CAMERA / PORT 1 =
Input from camera sync terminal, external trigger
button, Flash Confirmation Cable, or other device
Output to camera motor drive, flash, or other device
FLASH / PORT 2 = Output to flash, camera motor drive, or
other device
Status LED
Displays the following information:
Blinking every few seconds = power on, ready for trigger
Blinking in sync with trigger = normal triggering
Steady =
continuously triggered from radio, hot shoe, or PORT 1
performing delay or contact time
Once every two seconds = performing Intervalometer or Multi-pop function
Dark = power off or poor battery condition
•
•
•
•
•
•
•
•
•
–
–
•
•
•
•
–
–
•
•
Power Switch
Power Switch
Keypad
Keypad
Port 1, Port 2, Status LED
Port 1, Port 2, Status LED