Pocket Wizard MultiMAX Owner's Manual - page 18

1

Triggering Multiple Flashes With Multiple RECEIVE Units

Multiple remote flash units may be triggered in sync with each other.

1. Install batteries in each additional MultiMAX unit

2. Use flash cable to connect each additional flash unit’s sync terminal to FLASH / PORT 2

3. Set power switch on each additional MultiMAX unit to RECEIVE mode

4. Set all MultiMAX units to same channel as TRANSMIT unit 

You’re all set! Use the camera normally.

Connecting MultiMAX (set for TRANSMIT mode) to Flash

A flash can be connected to a MultiMAX (set for TRANSMIT mode). It will trigger in sync 

with the remote flash units. This flash is called the local flash and is usually mounted on a 

camera bracket.

1. Use a flash cable to connect the flash unit’s sync terminal to FLASH / PORT 2 of

the MultiMAX (set for TRANSMIT mode)

2. Use the L key to enable or disable the Local flash

You’re all set! Use the camera normally.

☞

   Using a local flash this way protects the camera from high voltages.  

See the Specifications section, Page 49, for more information.