Pocket Wizard MultiMAX Owner's Manual - Getting Started
1
GeTTInG sTarTed
Please pay attention to the following safety warnings:
Operating temperature: above -15° C (5° F) and below 50° C (120° F)
Storage temperature, without batteries: above -30° C (-22° F) and below 85° C (185° F)
Remove batteries during storage.
Battery Requirements: IEC:LR6 (AA) Size
Do not remove instrument covers during operation.
Do not operate the device in the presence of flammable gases or fumes.
Operation of any electrical instrument in such an environment constitutes
a definite safety hazard.
There are no user serviceable parts inside the MultiMAX. Do not install
substitute parts or perform any unauthorized modification of the instrument.
Refer servicing only to qualified and authorized personnel.
Red LED’s are used for dim light application and do not indicate a hazardous status.
The MultiMAX is an accessory device for cameras and flashes.
Do not use this product in a manner not specified in documentation.
•
•
•
•
•
•
•
•
•
Battery Information
CAUTION: Turn OFF your equipment (PocketWizard units, electronic flash
units, cameras, etc.) before making connections or changing batteries.
Install 2 fresh AA (IEC:LR6) batteries into the MultiMAX. Make sure to note
proper polarity. Alkaline batteries are recommended. Rechargeable batteries
will also work, though operation time may be reduced.
WARNING – To avoid battery leakage, follow these guidelines:
• Always remove the batteries when the unit is not in use for extended periods of time,
or during shipping or long distance travel.
• Never mix old and new batteries. Always use a fresh pair of matched batteries.
• Always change batteries promptly at the first indication of low battery operation.
• Do not use or leave the unit in extreme temperature or humidity situations.
See “Technical Information” for normal operating and storage temperatures.
N
Erratic unit behavior or malfunction may occur if batteries are inserted while the
power switch is set to either RECEIVE or TRANSMIT. Always make sure the power
switch is set to OFF before changing or inserting batteries.