Pocket Wizard MultiMAX Owner's Manual - Maximum and Minimum Settings
1
Maximum and Minimum Settings
The following table details the maximum and minimum values allowed for each numeric
entry setting available in the MultiMAX.
Setting
Maximum
Minimum
Contact Time
999.99 seconds or
16 minutes, 39.99 seconds
.01 seconds
Delay Time
9.9999 seconds
.0001 seconds (add 0.0005 to
displayed value for RECEIVE
units triggered via radio)
Interval (Intervalometer mode)
99:59:59 (1 second shy of 4 days,
4 hours or exactly 359,999 seconds)
1 second
Interval (Multipop mode)
999.99 seconds
(16 minutes, 39.99 seconds)
.01 seconds
Count (for Load Count or
Intervalometer / Multipop)
9999
0
Intervals are probably accurate to within +/- ~2.6 seconds per day based on the precision
of the internal crystal operating at 30 parts per million.
The maximum run time for Multipop, with count set to 9999, is over 115 days.
The maximum run time for Intervalometer, with count set to 9999, is just over 114 years. You
may need to use an AC adapter for this operation as batteries are unlikely to last 114 years.
Saved Settings
Settings are saved whenever the /MENU key is pressed. The following settings are
always RESET on normal power down:
Counter (resets to saved load value if count is
↓
, resets to 0 if count is
↑
)
Rear Curtain Sync (fraction display returns to 1/1)
Any dynamic numeric entry screen displayed as unit is powered off will default to
its previous saved setting. The screens affected are : Load counter, Delay time, and
Interval (Multipop or Intervalometer)
The following settings are saved on power down:
Channel
Beep Mode
Delay Time
Zone
Contact Time
Counter Mode
Interval
Relay Mode
Load Count
Advanced Mode
Fast Mode
•
•
•