Pocket Wizard MultiMAX Owner's Manual - Basic Setup For Remote Flash
1
QuICk seTuP - basIC radIo slave oPeraTIon
Basic Setup for Remote Flash
Turn off all equipment before installing batteries or making connections!
1. Install 2 AA batteries in each MultiMAX
2. Connect camera to first MultiMAX:
Slide unit into camera hot shoe
- or -
Use sync cable to connect camera’s PC terminal to CAMERA / PORT 1
3. Connect flash to second MultiMAX
Use flash cable to connect flash unit’s sync terminal to FLASH / PORT 2
4. Turn both MultiMAX units on
Set power switch on MultiMAX attached to camera to TRANSMIT mode
Set power switch on MultiMAX attached to flash to RECEIVE mode
5. Set both MultiMAX units to same channel and Quad-Triggering zone
Use ▲▼ to set channel (default is CH: 17)
Use A B C D L to select Quad-Triggering zones
(default is TRANSMIT = A B C D L, RECEIVE = A)
6. Turn camera and flash on
7. Press TEST button on MultiMAX (set for TRANSMIT mode) and release.
Confirm remote flash triggers.
You’re all set! Use the camera normally.
a.
b.
a.
a.
b.
a.
b.