Pocket Wizard MultiMAX Owner's Manual - B: Beep Menu –
B: Beep Menu –
/MENU B B
This menu controls the beep functions of a MultiMAX. Press
the corresponding letter to set the desired function of the built-in speaker.
A: Beep on All –
/MENU B B A
MultiMAX will beep on all triggering, confirmation errors, and
zero counts as indicated below as well as on any key pressed.
B: Beep on Trigger –
/MENU B B B
Beep on Trigger performs the same beeps as Beep On All
minus the double beep when the Counter hits zero in Count
Down, Multipop, or Intervalometer modes. Unit will beep
when triggered by TEST button, PORT 1, a Radio Trigger,
or the Hot Shoe per the table.
Beep Characteristic
Indicates
Single Short Beep
Indicates Proper Confirmation
Single Long Beep
Indicates Trigger Error
Single Very Short Beep
When any Key is pressed
C: Beep on Zero / Error –
/MENU B B C
The MultiMAX unit will not beep on normal triggering. The MultiMAX will beep only when
the counter reaches zero and on confirmation errors in the following manner:
Beep Characteristic
Indicates
Single Long Beep
Indicates Trigger Confirmation error or remote MultiMAX
(unit set for RECEIVE mode) has reached zero count
Double Long Beep
Indicates MultiMAX has reached zero count
Single Short Beep
Any Key is pressed except TEST
☞
A MultiMAX (set for RECEIVE mode) set to Beep on Zero / Error or set to Beep on All
will indicate a confirmation error if the unit is also set to count down and the counter
reaches zero. See the Counter section, Page 30, for more information.
D: Beep Disable –
/MENU B B D
Turns off all beep functions. Unit will not beep.
Beep Menu
Beep Menu