Pocket Wizard MultiMAX Owner's Manual - C: Multipop –

Î

  For delays longer than 9.9999 seconds (maximum available in delay modes) use 

Intervalometer or Multipop mode. Set the interval to the desired delay. Set the count 

to 1. Attach your camera to PORT 1 and trigger the MultiMAX . The camera will trigger 

after the set interval.

N

  Contact time is affected by Intervalometer mode. If you set an interval that is LESS 

than the contact time, the contact time becomes the interval minus 0.3 seconds. If 

you set an interval that is GREATER than the contact time, the contact time is simply 

performed as entered.

☞

   When using Intervalometer and Relay Mode together, a MultiMAX (set for RECEIVE 

mode) will switch to Transmit mode and send a Radio trigger after the last interval. 

See the Relay Mode section, Page 39, for more information.

☞

   When using Intervalometer or Multipop modes exclusively, battery life can be 200 - 300 

hours. See the Reset to Default Factory Settings section, Page 52, for more information.

C: Multipop – 

/MENU A C

Enters the Multipop interval setting screen. This mode is  

for triggering a flash multiple times from one trigger. It 

can be used during one long exposure to increase depth of 

field or for special effect sequencing. The interval setting is 

normally used to set a safe flash recycling time, while the 

count is set to the number of flashes or “pops” desired.

Multipop is identical in function to Intervalometer with one 

exception: the multipop interval range has finer resolution; 

from 0.01 to 999.99 seconds in 0.01 (1/100) second 

increments. This allows for finer control when setting flash 

recycle time. This mode can be used for cameras or flash units.

1. From the main screen press  /MENU A C to 

enter the numeric entry screen

2. Enter the interval or time gap between triggers

3. Press  /MENU to proceed to the next screen

4. Enter the count or number of triggers

5. Press  /MENU to return to the main screen. The 

interval will be displayed, and the count will show  

the number of triggers to be executed

6. Press the TEST key or trigger the MultiMAX via Radio to begin Multipop function

Multi-pop Mode 

Set Interval Screen

TRANSMIT Unit 

5.00 second Multi-pop Interval 

10 trigger Count

Multi-pop Mode 

Set Interval Screen

TRANSMIT Unit 

5.00 second Multi-pop Interval 

10 trigger Count