QTek 9090 User Manual - Fcc Compliance

                  Pocket PC Phone User Manual

 152

Pocket PC Phone User Manual

         153

Appendix B  Regulatory

Appendix B 

Regulatory

FCC Compliance 

Statement

n

FCC part 15, 22 and part 24

This  device  complies  with  Part  15  of  the  FCC 

Rules. Operation is subject to the following two 

conditions : (1) this device may not cause harmful 

interference, and (2) this device must accept any 

interference received, including interference that 

may cause undesired operation.

n 

FCC ID : NM8BLUEANGEL

n 

Statement according to FCC part 15.105

This equipment has been tested and found 

to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide 

reasonable protection against harmful 

interference in a residential installation. 

This equipment generates, uses and can 

radiate radio frequency energy and, if not 

installed and used in accordance with the 

instructions, may cause harmful interference 

to radio communications. However, there 

is no guarantee that interference will not 

occur in a particular installation. If this 

equipment does cause harmful interference 

to radio or television reception, which can 

be determined by turning the equipment 

off and on, the user is encouraged to try to 

correct the interference by one or more of the 

following measures.

n 

Reorient  or  relocate  the  receiving 

antenna.

n 

Increase the separation between the  

equipment and receiver.

n 

Consult the dealer or an experienced radio/

TV technician for help.

n 

Connect the equipment into an outlet on 

a circuit different from that to which the 

receiver is connected.

n

RF EXPOSURES

Tests for SAR are conducted using standard 

operating positions specified by the FCC with 

the phone transmitting at its highest certified 

power level in all tested frequency bands. 

Although the SAR is determined at the highest 

certified power level, the actual SAR level of 

the phone during operation can be well below 

the maximum value. This is because the phone 

is designed to operate at multiple power levels 

so as to use only the power required to reach 

the network. In general, the closer you are to 

a wireless base station antenna, the lower the 

power output. 

Before a phone model is available for sale to the 

public, it must be tested and certified to the FCC 

that  it  does  not  exceed  the  limit  established  by 

the  government-adopted  requirement  for  safe 

exposure. The tests are performed in positions and 

locations (e.g., at the ear and worn on the body) as 

required by the FCC for each model. (Body-worn 

measurements may differ among phone models, 

depending upon available accessories and FCC 

requirements).  While  there  may  be  differences 

between the SAR levels of various phones and at 

various positions, they all meet the government 

requirement for safe exposure. 

For body worn operation, to maintain compliance 

with FCC RF exposure guidelines, use only High 

Tech  computer,  Corp.  approved  accessories. 

When carrying the phone while it is on, use the 

specific  High Tech  Computer  Corp.  supplied  or 

approved  carrying  case,  holster,  or  other  body-

worn accessory.

Use of non High Tech Computer Corp. approved 

accessories  may  violate  FCC  RF  exposure 

guidelines and should be avoided.