T&D MCR-4V User Manual - Installing The Battery
17
Using MCR-4V
Installing the Battery
Remove the battery cover from the back of the device, and insert the
supplied two AA alkaline batteries as shown in the figure below.
After the batteries are inserted, the [Please set the clock] message will
appear on the LCD.
IMPORTANT
- Make sure to use new batteries of the same kind.
- Make sure not to mistake + / -.
- Do not insert or change batteries with wet hands.
- Be sure to completely close the cover.
- The MCR-4V cannot recharge batteries.
Usable Power Sources
- AA Alkaline Batteries
- AA Ni-MH Batteries
- AC Adapter (USB type)
- USB Bus Power
Changing the Batteries
If the battery runs down before it is replaced, MCR-4V will automatically
stop recording to protect data. Check the battery mark (see the previous
page) and change batteries as necessary.
IMPORTANT
- To protect data, please stop recording first before changing batteries. Not doing so
may result in loss of data being recorded.
- When you wish to replace batteries while recording is in progress, make sure to
connect the USB cable to your PC for USB bus power.
- If the MCR-4V runs out of power while processing data on a SD memory card, the data
on the card may be corrupted.