T&D MCR-4V User Manual - Before Using This Product

5

Before Using this Product

Please be careful about the procedures for Installation.

(For USB communication between your computer and a MCR-4V)

In order to use a USB connection to communicate between the unit and 

a computer, it is necessary to install the software and the USB device 

driver.

Make sure to fi rst install the software before connecting the unit to a 

computer. 

If you connect the unit first, the USB device driver may not 

be installed properly.

If you have connected the unit to your computer before installing the 

software, make sure to click [Cancel] in the Wizard window when it 

pops up on the computer display. Then disconnect the USB 

communication cable from the unit.