T&D MCR-4V User Manual - Starting Recording By Group
24
Starting Recording by Group
1.
Make recording settings for each device separately; no matter if it is a
Master or a Slave.
* See p.26 for a list of the possible setting items.
* See p.23 for the settings that are/are not controlled by the Master.
2.
From the main menu of the Master, select [Record Settings] - [Start
Recording].
3.
For the [Method], select [IMMED (grp)] or [PGM (grp)].
4.
Select [OK] and tap
IMPORTANT
All connected Slaves need to have power switched to ON.
Stopping Recording by Group
From the main menu of the Master, select [Record Settings] - [Stop
Recording].
IMPORTANT
- During Group Recording, if the bodies of the devices are disconnected from one
another, recording will continue on the Master but will stop on the Slave units.
- Even when devices are coupled, power will not be supplied from the Master to any
connected Slave units.
- When the Master stops recording, all Slaves will stop recording.
- During recording in one-time mode, if the Slave's memory capacity becomes full,
recording will stop on that Slave unit only.