TC Electronic SYSTEM 6000 MKII Algorithm Manual - page 100
100
rEflECTOr 6 & rEflECTOr lCr
Level
Adjusts the Output level for the tap (reflection). Height of
the tap indicates level.
Pan - Reflector 6
360-degree panner for positioning of the tap.
Pan - Reflector LCR
+/-30 degree (from Left to Right) panner for positioning of
the tap.
Shade
The tap color is a combination of the Shade response and
Diffusion type. When set to 0% no color change is applied,
when set to 100% full response according to the Shade
curve settings are applied.
On screen the Shade value is visualized from 0% = yellow
to 100% = red.
Note 1: When a * symbol is next to the parameter value,
this indicates that the Shade Master is different from 0,
meaning the resulting Shade value is different from the
individual setting.
Note 2: When ( ) symbols are around the parameter, this
indicates that the parameter is out of range due to the
Master Shade setting (resulting in more than 100%). When
settings are out of range, the relative differences between
taps are no longer preserved.
Feedback
Feedback parameter from 0 to 100%.
Note 1: When a * symbol is next to the parameter value,
this indicates that the Feedback Master is different from 0,
meaning the resulting Feedback value is different from the
individual setting.
Note 2: When ( ) symbols are around the parameter, this
indicates that the parameter is out of range. The Feedback
is out of range (and limited) to a total of 100% for all taps.
Put differently, when summing all 24 feedback values and
the Feedback Master, they cannot exceed 100% in total.
When settings are out of range, the relative differences
between taps are no longer preserved.
Phase
Selects 0 or 180 degree audio phase for each tap.
Taps set “out of phase” are visualized with a dot below the
tap.
Taps - Single Page
Using Single tap view, it’s possible to access the 24 taps
(reflections) individually. When selecting a tap, the six
corresponding parameters are assigned to the faders.
On screen, the dot above the tap indicates the currently
selected tap.
For parameter details see the Group view page.
The faders for the selected tap are also active
when displaying the hyper view page.
Taps - Hyper Page
Selecting Hyper view, accesses a 3D presentation of the
reflection pattern. This is a different way of seeing the
complete pattern, aware of arriving angle of reflections, but
also still showing Delay, Level, Shade and Phase.
To view the graphics from different angels, press and move
the Zero-Point with your finger.