TC Electronic SYSTEM 6000 MKII Algorithm Manual - Reverb - 2
32
rEvErb - 2
Main
Main
Decay
Range: 0.3 to 60.0s
Reverb diffuse field Decay time.
Pre Delay
Range: 0 to 200
Sets the time before the first reflection appears. Increasing
the Pre Delay will change the apparent position and, to
some degree, the size of the room.
Reverb Delay
Range: 0 to 100ms
Delay time on the Reverb diffuse field only. Where the Pre
Delay parameter sets the Delay time on the entire algorithm,
Early Reflections as well as diffuse field, the Reverb Delay
parameter works on the diffuse field only.
Hi Cut Freq
Range: 500Hz to flat
Hi Cut filter, shelving type. Provides an overall reverb high
frequency roll-off (6dB per octave), for creating a warmer
sound. Sets the Cut-off frequency of the overall Hi Cut filter
in 1/3-octave steps.
Hi Cut Att
Range: -40 to 0.0dB
The attenuation control sets the high frequency roll
determined by Hi Cut Freq.
Levels
Early Level
Range: -100dB to 0dB
The Output level of the Early Reflections. When Early Level
is set to off, the Reverb effect will consist entirely of Reverb
diffuse field.
Reverb Level
Range: off to 0.0dB
Sets the level of the reflection envelope relative to the Early
Reflections in 0.5dB steps. If Reverb Level is set to off you
will hear the initial reflections only.
In Level
Range: -100dB to 0dB
Sets the Input level of the algorithm.
Out Level
Range: -100dB to 0dB
Sets the Output level of the.
The Reverb 2 algorithm initially created for the TC M5000
compliments most types of source material, however
experience has shown that the Reverb 2 algorithm is
especially good on percussive instruments, as it has a very
well-defined precise buildup. The Reverb 2 algorithm is a
Stereo In/Stereo Out Reverb.
The Reverb-2 algorithm occupies:
@ Normal Sample Rate : 1/4 DSP Resource
@ Double Sample Rate : 1/4 DSP Resource
Algorithm Inputs/Outputs are distributed as follows:
E1 - E4
L
R
L
R
INPUT
OUTPUT
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•