TC Electronic SYSTEM 6000 MKII Algorithm Manual - Vss™ 5.1 - Source
25
vss™ 5.1 - sOurCE
Positions
Listening Position
In some large locations it’s possible to change the listeners
position. In the smaller locations there is one listening
position available.
Source 1 to 4 positioning
In the selected location it is possible to position the four
Input sources individually. Different numbers of positions
are available, depending on the location type and Output
format.
Sources page
This page contains individual parameters for each of the
four sources.
Source 1-4
Various parameters are available for each of the 4 source
positions. Press
Source
1-4
to select which set of source
parameters you wish to adjust.
Source 1-4 Early Reflections
Lo Color
Range: +/-50
Adjusts the low frequency spectrum for the selected Source.
Hi Color
Range: +/-50
Adjusts the high frequency spectrum for the selected Source.
Early Start
Range: 0 to 100%
Sets the starting point of the initial taps in the Early
Reflection pattern (The shortest taps).
The parameter range limit will be less than 100%
if the Early Stop parameter is set to anything other
than 0%.
Early Stop
Range: 100 to 0%
Removes taps in the Early Reflection pattern from the end
of the pattern.
The parameter range limit will be less than 100%
if the Early Start parameter is set to anything other
than 0%.
Reverb Position
Enables to emphasize or change the Source position origin
in the Reverb part of the algorithm.
Source 1-4 Levels
ER Level
Range: -100 to 0dB
Adjusts the level of the Early Reflection for the source.
Reverb Level
Range: -100 to 0dB
Adjusts the level of the source contribution to the five
Reverb Tails.
Dry Level
Range: -100 to 0dB
Adjusts the level of Dry signal from the source.
In Level
Range: -100 to 0dB
Adjusts the overall Input level from the source.
Reverb page
At the Reverb page you access Color and Decay
parameters for the five reverb diffuse fields.
Reverb Colors
Lo Color
Range: +/-50
Adjusts the spectral balance in the low end frequencies of
the Reverb. All five diffuse fields respond to this parameter.
Mid Color
Range: +/-50
Adjusts the spectral balance in the mid-range frequencies
of the Reverb. All five diffuse fields respond to this
parameter.