TC Electronic SYSTEM 6000 MKII Algorithm Manual - Toolbox - 5.1
69
TOOlbOX - 5.1
Output Format
Range: 5.1 (=Off or Thru), LCRS, Stereo or Mono
Selects the Output format in which your five main channels
Input material will be mixed down to.
90º Mono
90 degrees mono Insert. This option is placed just before
the two Limiters, meaning at LFr + RFr when Output format
is set to Mono, and LSr + RSr channels when LCRS is
selected as Output format.
Mono Output
Range: Center, LFr+RFr
Selects the Output channel when Mono is selected as
Output format.
Mix Levels
From L/R
Range: -100dB to 0dB
Sets the Input level from the Left and Right front channels.
This parameter is only available when Output is set
to Mono or Stereo.
From Center
Range: -100dB to 0dB
Sets the Input level from the Center channel.
This parameter is only available when Output is set
to Mono or Stereo.
From SL/SR
Range: -100dB to 0dB
Sets the Input level from the Left and Right surround
channels.
Output limiter
Two channels of broadband Output brickwall limiter, that
are placed differently according to the selected Output
format.
Output format: 5.1 Thru
The Limiter is inactive.
Output format: LCRS
The Limiter operates on the LS and SR channels.
Output format: Stereo
The Limiter operates as a Stereo Limiter on Left and Right
front channels.
Output format: Mono
The Limiter operates on the Mono sum Output.
Threshold
Range: -12 to 0dB
Limiter Threshold level for the two limiters available. The
Limiters will be placed at LFr + RFr Outputs when Stereo
or Mono mode is selected as Output formats, and at LSr +
RSr when LCRS is selected as Output format.
Release
Range: 10 to 1000 ms
Sets the Release time for the selected Limiter.
Bass Page
Bass Management
Range: Extract, Distribute, Inactive
When the LFE Mode parameter is set to Distribute, the
Bass Management enables you to add LFE information to
the six Output channels in the system. This can normally
be compared to a 5.1 -> 5.0 process, but it can also be a
5.1 -> 5.1 process, leaving the LFE channel unprocessed,
while adding LFE information to the five Main-channels.
The Bass Management is placed just before the Output
Format conversion.
Main Channels
Lo Cut
Range: 10 - 200Hz
Sets the frequency for the Lo Cut filter, on the five main
Output channels (LFr, RFr, Cen, LSr, RSr)
Order
Range: Off, 2nd, 4th order
Sets the slope of the Main channels Lo Cut filter.
LFE Channel
Hi Cut
Range: 10 - 200Hz
Sets the frequency for the Hi Cut filter on the LFE channel.
Order
Range: Off, 2nd, 4th order
Sets the slope of the LFE Hi Cut filter.