TC Electronic SYSTEM 6000 MKII Algorithm Manual - Rev Core - 2
37
rEv COrE - 2
Reverb
Early Reflections
Shape
Range: Hall, Fan Prism, H Shoe, Club and Small.
Select one of the above to simulate a specific room shape.
Size
Range: 0.040 - 4.000s
Scales the dimensions of the simulated space depending
on the SHAPE chosen. The specific room that is being
simulated is scaled 1:1 at SIZE =1.00. This can then be
scaled up or down. Provided that the predelay setting is
relatively short, the corresponding volume of the simulated
space is changed radically with this control.
Xfeed
Range: On/off
With this parameter switched off, the Cross-feeds in the
Early Reflections will be killed. With Xfeed set to off,
and the Width parameter set to 100%, a true stereo Reverb
is created. The effect from the left and the right channel will
be generated totally independently. The feature is especially
applicable for the film industry and post production suites.
Reverb
Lo Decay
Range: 0.01 to 2.5 times
Relative Decay time multiplier for low frequencies.
Lo Xover
Range: 20Hz to flat
Sets the frequency at which the transition from the low to
the low-mid frequencies takes place.
Hi Decay
Range: 0.01 to 2.0 times
Multiplier for the high frequencies. If Hi Decay is set to 0.5,
the Hi Decay time is half that of the nominal Decay setting.
Hi Xover
Range: 20Hz to flat
Sets the frequency at which the transition from the mid
frequencies to the high frequencies takes place.
Width
Range: 0 to 100 %
Sets the apparent stereo width of the reverberating part of
the algorithm. At “0” the diffuse field will appear to be
coming mainly from the center (mono compatible),
whereas with Width set to “100” the L/R reverberators are
independent.
Hi Cut Freq
Range: 500Hz to flat
Rolls off the top end as it enters the Reverb Diffuse Field.
Use this parameter to “darken” the room.
Hi Cut Att
Range: -40.0 to 0.0dB
The attenuation control sets the high frequency roll
determined by the Hi Cut Freq. parameter.
Diffuse
Range: -50 to 50
This parameter gives you more or less Diffusion than the
algorithm designer intended for the given Decay time.
For optimum performance the diffusion is automatically
adjusted behind the scenes whenever you change Decay
times. This parameter gives you the added control to vary
the Diffusion around this automatic setting.