TC Electronic SYSTEM 6000 MKII Algorithm Manual - Vss
9
vss
TM
3
Rev Balance
Range: -100dB R, center, -100dB L
The left/right balance of the Reverb. Allows you to offset the
diffuse field from the normal center position.
Diffuse
Range: -50 to +50
This parameter gives you more or less diffusion than the
algorithm designer intended for the given Decay time. For
optimum performance the diffusion is automatically adjusted
behind the scenes whenever you change Decay times.
This parameter gives you the added control to vary the
diffusion around this automatic setting.
Decay/Crossover
Lo Decay
Range: 0.01 to 2.5
Multiplier for the frequencies below the Lo Xover frequency.
Example: If the Main Decay parameter is set to 2.0sec and
the Lo Decay parameter is set to 1.5, frequencies below
the Lo Xover will decay for 3.0 sec.
Conversely if this parameter is set to 0.5 the Decay time
below the Lo Xover point will be only 1 sec.
Lo Xover
Range: 20Hz to 500Hz
Sets the frequency at which the transition from the low to
the low-mid frequencies takes place.
Lo Mid Decay
Range: 0.01 to 2.5
The Ratio control multiplier for the low-mid frequencies.
Mid Xover
Range: 200Hz to 2kHz
Sets the frequency at which the transition from the low-mid
to the mid frequencies takes place.
Hi Mid Decay
Range: 0.01 - 2.5
The Ratio control multiplier for the mid frequencies. This
parameter is normally set to 1.0 as it is the main parameter
adjusted by the main Decay parameter. This mid-range
decay control would normally be omitted, however, TC
Engineers felt you could use this parameter as a fine
adjustment tool to “tweak” a preset to sound just right
without having to adjust the master Decay parameter.
Hi Xover
Range: 500Hz to 20kHz
Sets the frequency at which the transition from the mid
frequencies to the high frequencies takes place.
Hi Decay
Range: 0.01 to 2.5
Multiplier for the frequencies above the Hi Xover frequency.
Example: If the main Decay parameter is set to 2.0sec and
the Hi Decay parameter is set to 1.5, frequencies above
the Hi-Xover will decay for 3.0 sec. Conversely if this
parameter is set to 0.5 the Decay time above the Hi Xover
point will be 1 sec.
Modulation
Reverb Modulation
RevMod Type
Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild
Selects the type of modulation.
RevMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from the factory
default assigned to each Type.
RevMod Width
Range: 0% to 200%
Sets the Width of the modulation.
Space Modulation
SpcMod Type
(Off, Normal, Fast, Slow, MidFreq, Sync)
Selects the type of Space Modulation.
SpcMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from the factory
default assigned to each type.
SpcMod Width
Range: 0 to 100%
Sets the width of the modulation.
SpcMod Depth
Range: -50, default, +50
Allows you to offset the amount of space modulation from
the factory default.