TC Electronic SYSTEM 6000 MKII Algorithm Manual - Vss™Sr (Surround)
12
vss™sr (surrOunD)
Diffuse
Range: -50 to +50
This parameter gives you more or less diffusion than the
algorithm designer intended for the given Decay time. For
optimum performance the diffusion is automatically
adjusted behind the scenes whenever you change Decay
times. This parameter gives you the added control to vary
the diffusion around this automatic setting.
Decay/Crossover
Lo Decay
Range: 0.01 to 2.5
Multiplier for the frequencies below the Lo Xover frequency.
Example: If the Main Decay parameter is set to 2.0sec and
the Lo Decay parameter is set to 1.5, frequencies below
the Lo Xover will decay for 3.0 sec.
Conversely if this parameter is set to 0.5 the Decay time
below the Lo Xover point will be only 1 sec.
Lo Xover
Range: 20Hz to 500Hz
Sets the frequency at which the transition from the low to
the low-mid frequencies takes place.
Lo Mid Decay
Range: 0.01 to 2.5
The Ratio control multiplier for the low-mid frequencies.
Mid Xover
Range: 200Hz to 2kHz
Sets the frequency at which the transition from the low-mid
to the mid frequencies takes place.
Hi Mid Decay
Range: 0.01 to 2.5
The Ratio control multiplier for the Hi-mid frequencies.
Hi Xover
Range: 500Hz to 20kHz
Sets the frequency at which the transition from the mid
frequencies to the high frequencies takes place.
Hi Decay
Range: 0.01 to 2.5
Multiplier for the frequencies above the Hi Xover frequency.
Example: If the main Decay parameter is set to 2.0 sec and
the Hi Decay parameter is set to 1.5, frequencies above
the Hi-Xover will decay for 3.0 sec. Conversely if this
parameter is set to 0.5 the Decay time above the Hi Xover
point will be 1 sec.
Rev Depth
Range: Center, Stereo, Deep
With this parameter you can change the perceived Depth
of the Reverb.
Mod
Reverb Modulation
RevMod Type
Range: Off, Smooth 1, Smooth 2, Perc, Wow, Vintage,
Wild.
Selects the type of modulation.
RevMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from the factory
default assigned to each Type.
RevMod Width
Range: 0% to 200%
Sets the Width of the modulation.
Space Modulation
This group of parameters sets the way the sound moves
about the room.
SpcMod Type
Range: Off, Normal, Fast, Slow, MidFreq, Sync.
Selects the Type of Modulation.
SpcMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from the factory
default assigned to each type.
SpcMod Width
Range: 0% to 100%
Sets the width of the modulation.
SpcMod Depth
Range: -50, default, +50
Allows you to offset the amount of space modulation from
the factory default.