Wacker Neuson BTS 630 Operator's Manual - page 39
Other manuals for BTS 630:
Use And Operation
Manual is about: Gasoline cut-off saw
of
80
BTS 630, 635
8 Initial start up
Operator's manual
39
Mounting the cutting attachment on the outside
1. Remove the cutting attachment.
2. Clean the cutting attachment, V-belt pulley, belt guard and screws.
3. Rotate the cutting attachment 180° and place it in position.
4. Place the V-belt in position.
5. Place the belt guard in position and affix it with screws.
6. Rotate the adjusting screw clockwise until the square nut is located between
the two marks.
7. Tighten the belt guard screws.
Torque 25 Nm.
8. Position the hose connections and tighten them.
Item
Designation
Item
Designation
1
Hose connection (2 pieces)
3
Adjusting screw
2
Belt guard
4
Screw (2 pieces)