Wacker Neuson BTS 630 Operator's Manual - page 42
Other manuals for BTS 630:
Use And Operation
Manual is about: Gasoline cut-off saw
of
80
9 Use and operation
BTS 630, 635
42
Operator's manual
Changing the cutting blade
1. To block the shaft, put an Allen wrench into the bore.
Note: If necessary, rotate the spindle until the Allen wrench engages in the
bore.
2. Unscrew and remove the screw together with the thrust washer.
3. Clean thrust washer and spindle of the machine.
4. Place the cutting blade onto the spindle in the correct rotation direction.
5. Place the screw together with the thrust washer in position and tighten.
Torque 23 Nm.
6. Remove the Allen wrench from the bore.
7. Test the new cutting blade for approx. 1 min at maximum speed (without
cutting).
Item
Designation
Item
Designation
1
Bore
4
Thrust washer
2
Spindle
5
Screw
3
Cutting blade