Wacker Neuson BTS 630 Operator's Manual - page 63
Other manuals for BTS 630:
Use And Operation
Manual is about: Gasoline cut-off saw
of
80
BTS 630, 635
10 Maintenance
Operator's manual
63
10.3.9 Setting the idle speed
1. Start the engine.
2. Allow the engine to warm up.
3. Set the idle speed with a screwdriver:
If the cutting blade rotates in idle, turn the adjusting screw for idle speed
counter-clockwise until the cutting blade stops.
If the engine shuts off in idle, turn the adjusting screw a bit clockwise.
Note: If the cutting blade still rotates after setting the idle speed, have it repaired
by your Wacker Neuson representative.
Item
Designation
1
Adjusting screw