WEG PLC300 User Manual - page 33

Configuration of the PLC300

PLC300 | 7-3 

The arrows select the mode that is activated only if is pressed.

exits without changing the mode.

A n a l o g I n p u t

- - - - - - - - - - - - - - - - - - - -

V o l t a g e 0 t o 1 0 V

7.6  IOA CARD (AOS)  

Selects one of the four operating modes of the analog outputs (AOs) of the IOA accessories 

installed, seeing that the AOs 101 and 102 are the AOs 1 and 2 of the IOA card installed in 

the slot 1 of the PLC300, and the AOs 201 and 202 are the AOs 1 and 2 of the IOA card 

installed in the slot 2.

I O A C a r d ( A O S )

- - - - - - - - - - - - - - - - - - - -

> A O 1 0 1 : 0 t o 1 0 V

A O 1 0 2 : 0 t o 1 0 V

The arrows   and select the AO to be changed. By pressing , the cursor 

flashes in the operating mode to be changed.

The arrows   and browse through the possible operating modes:  

0 to 20 mA, 4 to 20 mA, 0 to 10 V and -10 to +10 V.

accepts the changed value. aborts.

  returns to the main menu of the setup.

7.7 ENCODER SUPPLY 

Selects the power supply of the encoder between 5 or 12 V.

The arrows select the wanted voltage, which becomes valid only if is pressed.

exits without changing the encoder voltage.

E n c o d e r S u p p l y

- - - - - - - - - - - - - - - - - - - -

E n c o d e r 1 2 V

7.8 RS-232 SETUP

It is possible to configure the baud rate, the parity and the number of stop bits of the RS-

232 serial interface.