WEG PLC300 User Manual - page 35
Configuration of the PLC300
PLC300 | 7-5
Address:
1 to 247.
In the editing of the address, in addition to the upward and downward keys, the number can be
typed directly by the numeric keyboard. The key returns to the initial value, with no change.
7.10 CAN SETUP
It is possible to configure the baud rate and the address of the PLC300 in a CANopen
network, through the CAN Interface.
The arrows and select the option to be changed. By pressing
cursor flashes in the operating mode to be changed.
C A N S e t u p
- - - - - - - - - - - - - - - - - - - -
> B a u d R a t e : 1 M b p s
A d d r e s s
: 0 0 1
The arrows and browse through the possible values:
Baud rate:
20, 50, 100, 125, 250, 500 (Kbps), 1 Mbps
Address:
1 to 127
In the editing of the address, in addition to the upward and downward keys, the number
can be typed directly by the numeric keyboard. The key returns to the initial value,
with no change.
7.11 LAN SETUP
It is possible to configure the IP address, subnet mask, default gateway, DHCP, speed and
duplex mode of the PLC300 in an Ethernet network.
L A N S e t u p
- - - - - - - - - - - - - - - - - - - -
> I P A d d r e s s :
1 9 2 . 1 6 8 . 0 0 0 . 0 1 0
S u b n e t :
2 5 5 . 2 5 5 . 2 5 5 . 0 0 0
G a t e w a y :
0 0 0 . 0 0 0 . 0 0 0 . 0 0 0
D H C P :
D i s a b l e d
S p e e d / D u p l e x :
A u t o