WEG PLC300 User Manual - page 40

Configuration of the PLC300

7-10 | PLC300

The menu output is executed by timeout, i.e., in about 10 s without operation, the PLC300B 

display will show the status of the I/Os again.

EDITING OF THE EQUIPMENT NUMBER (BLIND VERSION, WITHOUT HMI)

To edit the number of the equipment, press the key for some seconds, then the cursor 

flashes on the number.

The number of the equipment always goes back to 0001 when it enters the editing mode 

in the blind version (without HMI).

Short strokes on the key will increment the number; if the key remains pressed, the number 

is increased rapidly.

To accept the entered value, simply release the key; in about five seconds the editing mode 

is completed, maintaining the current value and returning to the backup menu.

7.14 USER PROGRAM

Allows to stop or execute the user program. 

The current status of the program is also shown.

The key selects between ‘Stop’ or ‘Run’.

U s e r P r o g r a m

- - - - - - - - - - - - - - - - - - - -

S t a t u s : R u n n i n g

> S t o p

In the option ‘

Stop’ or ‘Execute’ ENTER or arrows, toggles the value, that is, if the program 

is running the message ‘Stop’ changes to ‘Execute’ and the program is stopped.

  returns to the main menu of the setup.

7.15 SETUP MENU PASSWORD

Allows changing the password of the setup function. 

The standard password is ‘0000’. The new password must be a number with four digits.

C h a n g e   S E T U P P a s s w d

- - - - - - - - - - - - - - - - - - - -

N e w p a s s w o r d :

Type the new password and press .

The arrow or keys serve as backspace.