WEG PLC300 User Manual - page 34
Configuration of the PLC300
7-4 | PLC300
R S 232 S e t u p
- - - - - - - - - - - - - - - - - - - -
> B a u d R a t e : 9 6 0 0 b p s
P a r i t y : N O
S t o p B i t s : 1 s b
The arrows and select the option to be changed. By pressing
cursor flashes in the operating mode to be changed.
The arrows and browse through the possible values:
Baud rate:
1200, 2400, 4800, 9600,19200, 38400 or 57600 bps.
Parity:
NO,ODD,EVEN.
Stop bits:
1 or 2sb.
7.9 RS-485 SETUP
It is possible to configure the baud rate, the parity and the number of stop bits, the mode
(master/slave/telegram
1
) and the address of the PLC300 in a Modbus RTU network by
means of the RS-485 serial interface.
R S 4 8 5 S e t u p
- - - - - - - - - - - - - - - - - - - -
> B a u d R a t e : 1 9 2 0 0 b p s
P a r i t y
: N O
S t o p B i t s : 1 s b
M o d e
: M a s t e r
A d d r e s s
: 0 0 1
The arrows and select the option to be changed. By pressing
cursor flashes in the operating mode to be changed.
The arrows and browse through the possible values:
Baud rate:
1200, 2400, 4800, 9600, 19200, 38400 or 57600bps.
Parity:
NO,ODD,EVEN.
Stop bits:
1 or 2sb.
Mode:
Master, Slave or Telegram.
(1) There are two modes reserved for future aplications.