WEG SCA06 User Manual - page 13
2
General Information
SCA06 | 2-3
2.3 ABOUT THE SCA06
The servo drive SCA06 is a high-performance product which allows controlling the speed, torque and position
of three-phase, sine-wave, alternate current servomotors. The main characteristic of this product is the high
performance and high precision of movement control of the servomotor shaft due to the operation in closed loop
by means of the position feedback given by a sensor inside the servomotor.
The SCA06 features independent control and power supply, allowing, for instance, that the product communication
networks keep on working normally even if the power circuit must be turned off for some reason.
The use of braking resistors provides greatly reduced braking times, optimizing the processes that require high
performance.
Several special functions are available, such as programming in ladder with positioning blocks, which provides
extreme flexibility and integration to the drive.
The SCA06 can be used in different applications with many options of cables, both for simple applications and
complex applications like handling, environments with oil, etc.
Servo drive
SCA06
+UD
-UD
BR
L1
L2
L3
37
36
35
34
33
32
31
30
29
27
21
20
26
25
24
23
22
19
18
17
15
14
16
13
11
12
28
10
09
08
07
05
03
04
06
02
01
CAN
STO
STO1
EMC
+24 V
Ref.
PE
PE
PE
PE
PE
PE
PE
SM
W
V
U
STO2
FB
USB
I/O
I/O
I/O
I/O
HMI
MEMORY
1 – Braking resistor
2 – Power supply connector (X9)
3 – Power supply
4 – Servo drive grounding
5 – RFI filter card (optional)
6 – RFI filter disconnection
7 – Ground fault detection
8 – Rectifier
9 – Pre-load
10 – DC link
11 – Internal source (optional)
12 – Power supply
13 – Voltage feedback
14 – Overcurrent protection
15 – Braking chopper
16 – Safe torque off card (optional)
17 – IGBT bridge
18 – Current feedback
19 – Output connector for servomotor (X8)
20 – STO control connector (X7)
21 – Control supply connector (X5)
22 – Servomotor power cable
23 – Control cable of the servomotor brake
24 – Control connector of the servomotor brake
25 – Servomotor power connector
26 – Servomotor feedback connector
27 – Servomotor feedback cable
28 – Control card
29 – Flash memory card.
30 – Man machine interface
31 – Connector for accessory (Slot 1)
32 – Connector for accessory (Slot 2)
33 – Connector for accessory (Slot 3)
34 – Input/output connector (X1)
35 – USB communication network (X3)
36 – CAN communication network (X4)
37 – Feedback connector (X2)
Figure 2.1: Block diagram of the SCA06