WEG SCA06 User Manual - page 58
7
Troubleshooting and Maintenance
7-4 | SCA06
7.5 TECHNICAL ASSISTANCE CONTACT INFORMATION
NOTE!
For obtaining information or requesting service, it is important to have the following data at hand:
Servo drive model.
Serial number and manufacturing date contained on the product identification label (see
section
2.4 IDENTIFICATION LABEL OF THE SCA06 on page 2-5
).
Firmware version installed (see P0023).
Information about the application and programming executed.
Servomotor model.
7.6 PREVENTIVE MAINTENANCE
DANGER!
Always disconnect the general power supply before touching any electrical component part
associated to the servo drive.
High voltages can be present even after the disconnection of the power supply.
Wait for at least 10 minutes for the complete discharge of the power capacitors or wait until the
red Power on LED turns off.
Always connect the frame of the equipment to the protective earth (PE) at the proper point.
DANGER!
Débranchez toujours l'alimentation principale avant d'entrer en contact avec un appareil électrique
associé à la servocommande.
Il peut rester une tension élevée même après la déconnexion de l'alimentation électrique.
Attendre au moins 10 minutes pour que les condensateurs se déchargent complètement ou
attendre que la LED d'état rouge s'éteigne.
Raccordez toujours la masse de l'appareil à une terre protectrice (PE).
ATTENTION!
The electronic cards have components sensitive to electrostatic discharges.
Do not touch directly the component parts or connectors. If necessary, first touch the grounded
metallic frame or use a proper grounding strap.
Do not carry out any applied potential test in the servo drive!
If necessary, contact WEG.
When installed in proper environment and operating conditions, the servo drives require little service.
Table 7.2
on page 7-5
lists the main procedures and intervals for routine maintenance.
Table 7.3 on page 7-5
lists the semiannual inspections suggested for the product after startup.