WEG SCA06 User Manual - page 44
4
HMI
4-2 | SCA06
DECREASE: Key used to navigate in a decreasing way through the parameters, or, when in the
modification mode, decrease the content of the respective parameter.
INCREASE: Key used to navigate in an increasing way through the parameters, or when in the modification
mode, increase the content of the respective parameter.
SHIFT: When the key is pressed in the View mode the parameter returns to the Search mode, displaying
the parameter number. When pressed in the View mode, it allows the user to move the digit he wishes
to change and the digit will show flashing in the HMI, indicating that it is the selected. For example:
P00105 in the Modification mode: HMI displays the value 00200 with the digit 1 (value 0) flashing. The
user wishes to modify the 5th digit. In order to do so, the user must press the SHIFT key four times;
then the digit 5 (value 0) will start flashing indicating that, when pressing the increase or decrease key,
its value will be modified.
Reset
Located above the HMI keys, this key is accessed with a small screwdriver or similar tool. Its effect is the
same as turning off and back on the control, that is, whenever it is pressed, the software of the servo
drive will reinitialize.
General Notes:
To modify the value of a parameter, it is necessary first to adjust P00000 = Password Value, except when
the option “Disable Password” is activated (P00200 = 0). The default password value is P00000 = 00005.
Otherwise, it will only be possible to view the parameters, but not to modify them.
4.2 LEDs
USB LED
It indicates there is communication between the servo drive and some other device connected to the USB network.
Power on LED
It indicates that the power circuits are connected or with residual energy in case the servo drive is OFF.
DANGER!
Never touch the terminals and/or components of the servo drive while the power on LED is ON.
DANGER!
Ne jamais toucher les bornes et/ou les composants de la servocommande lorsque la LED d'état
est allumée.
Fault LED
It indicates that there was a fault in the servo drive. The fault code can be seen in the HMI of the servo drive and
solved by referring to
chapter 7 TROUBLESHOOTING AND MAINTENANCE on page 7-1
.