Yamaha M7CL StageMix V1.5 Supplementary Manual - page 3
3
You can now use the top panel faders to adjust the send
levels from input channels not only to MIX buses but also
to MATRIX buses.
In SENDS ON FADER mode, you can now use the MIX/
MTRX ON FADER button to switch between the MIX
buses and MATRIX buses as the send destinations.
[When MIX ON FADER mode is ON]
[When MATRIX ON FADER mode is ON]
1
MIX/MTRX ON FADER select button
Each time you press this button, you’ll switch between MIX
ON FADER mode and MATRIX ON FADER mode.
B
MIX/MATRIX bus select button
Use these buttons to switch the send destination MIX bus or
MATRIX bus. The buttons will be joined if two buses are set
to stereo.
In SENDS ON FADER mode, the send-destination
MATRIX bus can now be selected by pressing the
[MATRIX] navigation key and then pressing a [SEL] key
in the Centralogic section.
Until now, EQ and dynamics were managed as individual
libraries, but now the channel parameters (including HA
settings) can be managed together in units of channels as
channel library data, and stored, recalled, or cleared from
internal memory.
You can recall 200 different settings each from the input
channel library and the output channel library. For both
input and output libraries, only 000 (Initial Data) is a read-
only preset.
The basic operations are the same for input channels and
output channels.
1
Use the [SEL] keys to select the channel
whose settings you want to manage.
2
Press an encoder of the SELECTED CHAN-
NEL section to access the SELECTED
CHANNEL VIEW screen.
3
Press the LIBRARY tool button to access
the INPUT CHANNEL LIBRARY window /
OUTPUT CHANNEL LIBRARY window.
The library window contains the following items.
[INPUT CHANNEL LIBRARY]
Using the faders to adjust the
send levels to the MATRIX buses
(MATRIX ON FADER mode)
1
2
1
2
Using the Centralogic section’s
[SEL] keys to select a MATRIX bus
Input/output channel library support
Using the channel library
3
4
5
6
m7cl̲v2̲en.fm Page 3 Thursday, June 25, 2009 5:16 PM