Zadako GECON LITE PLUS Installation Manual - page 14
14
Setting of timer of external siren
This setting is done by commands abcd ALARM=30
This command will cause the siren to sound for 30 seconds. Allowed range is from 0 to 240 seconds. 0 will disable
the siren during the alarm event.
Note: Commands ALARM and IBUT=on will cancel previous settings of RELAY. Vice versa, all RELAY commands
will cancel siren settings.
Arming of the control panel:
In disarmed status, Gecon lite plus shall signalize as follows: blue LED diodes on the reader shine permanently
and LED diode on the board shines permanently. After attaching valid Dallas key, buzzer will beep shortly twice
and subsequently, short beeps together with short blinks of LED diodes signalize exit delay of 20 seconds (time is
configurable). Last 6 seconds is signalized by faster beeps. If during exit delay one of alarm inputs is activated,
long beep will sound and arming process needs to be restarted. The start of armed status is signalized by two long
beeps and red signalization LED will shine permanently. In the moment of arming, no loop cannot be activated,
otherwise the arming process will not finish.
Disarming of the control panel:
In armed status, red LED diodes on control panes are shining. Entry to the protected space is usually accompanied
with activation of alarm detectors connected to Gecon lite plus input loops. This is signalized by short beeps of
buzzer and blinks of blue LED diodes. During entry delay (default 20seconds, configurable) Dallas key needs to be
attached to the control panel. This is signalized by accepting double beeps and permanent shine of blue LED
diodes. If the Dallas key is not connected, alarm is triggered. Gecon lite plus performs all predefined actions such
as relay activation, alarm calls and SMS reports. Alarm can be cancelled by attaching of valid Dallas key to the
control panel.