Zadako GECON LITE PLUS Installation Manual - page 7
7
Additional functions
These function specify or modify basic functioning of Gecon Lite plus Gateway.
Reports routing
By default, all events (alarms and troubles) are reported to all numbers in address book. This setting is
possible to change, that selected phone numbers (T1-4) will be only reported about events on selected inputs. In
this way, you can sort out the reports according to the level of importance.
VT1=1234 - T1 will be informed about events on all inputs
VT2=34 - T2 will be informed about events on inputs 3 and 4
Example:
VT1=2 - events from input 2 are reported to phone number T1
Note:
Every setting of new phone number with T1 –T4 commands resets this routing to default, meaning that newly set
number will be informed about all events on all inputs.
Input delay
For some applications, it is necessary that the events will be reported only in the case their duration
is longer as defined period. In this way you can filter out the events that have no impact on the protection of the
building.
Input delay is by default set to 0 minutes, meaning that the event is reported immediately. You can set the
parameter between 0 and 120 (minutes). You can set it following:
D1=time delay of input 1 reporting and time in minutes
D2=time delay of input 2 reporting and time in minutes
For example, in most cases it is not necessary to report power cuts immediately (circuit breakers could be switched
back on in few minutes). But power cuts longer than few minutes shall be reported.
D1=30 - input 1 will report only events lasting longer than 30 minutes.
Alarm filtering:
Alarm filtering is a cost-saving function.
If the time filter is on, subsequent alarms triggered on the same inputs are ignored by Gecon. The idea is not to
report any addition alarms during predefined time period (in minutes). This function can save you the prepaid
credit. This function is off by default that means set to 0 minutes. Filter works independently for every input.
Example:
Set time filter for 15 minutes.
abcd F=15
Example:
Turn time filter off: abcd F=0