Zebra Rw 220 User Manual - Battery Safety

11

RW Series User Guide

Getting Ready to Print

Battery Safety

The Battery Packs used on Zebra Mobile Printers contain a 

great deal of energy and can cause personal injury or start a 

fire if used improperly or carelessly. Please observe the fol-

lowing safety practices:

  Caution • Avoid accidental short circuiting of any battery. Allowing 

battery terminals to contact conductive material will create a short 

circuit which could cause burns and other injuries or could start a fire.

  Caution • Batteries  can explode or catch fire if improperly charged 

or exposed to high temperatures or fire.  Do not disassemble, crush or 

expose batteries to water. 

Caution • Use of any charger not approved specifically by Zebra for use 

with its batteries could cause damage to the battery pack or the printer 

and will void the warranty.

  Read carefully and always observe the safety guidelines for Li-Ion 

batteries provided with each Battery Pack.

Charger Safety

  Do not place the LI72-4 Quad Charger in  locations where liquids or 

metallic objects may be dropped into the charging bays. 

   Use care in locating either the LI 72 Single Charger or the LI 72-4 Quad 

Charger.   Do not block the ventilating slots on the top and bottom 

covers.  Ensure that the Charger is plugged into a power source 

which won’t accidently be turned off if you will be charging batteries 

overnight.

  Required Regulatory Text for Argentina

Only certified adaptors with the following electrical characteristics 

shall be used. The use of different adaptors could damage the device, 

present hazards to the user and declare the correspondent guaranty 

void. 

LI 72: 

Input ratings: 100-240 VAC 50/60Hz 200mA., Class 2 

Output ratings: 8.4 VDC, 800 mA