Zebra Rw 220 User Manual - page 42

42

RW Series User Guide

The MSR is used as follows:

1. When the reader is enabled, place the card into the read-

er slot as shown.  The magnetic stripe (typically on the 

back of the card) must face the bottom of the printer, and 

be inserted into the bottom of the card reader slot as 

shown in Figure 17.

2. Slide the card through the slot.  The card will be read 

if slid in either direction.  Depending on the application 

software, the printer will sound one chime when a scan is 

successful .

3. If the card did not read, slide it back through the slot in 

the opposite direction.

Figure 17: Using the Magnetic Stripe Reader

Magnetic Stripe Card

Place the Card in the reader slot with the magnetic stripe 

facing down as shown.

Card can be read in both direc-

tions.

Magnetic 

Stripe Reader 

Slot