Zebra Rw 220 User Manual - Charging The Battery

13

RW Series User Guide

Installing RW Series Batteries

  Important • Batteries are shipped uncharged.  Remove protective 

shrink-wrap and labels from new battery packs prior to use.

1. Rotate the Belt Clip to allow access to the Battery com-

partment.  This is an optional step on the RW 220.

2. Insert the battery into the printer as shown in Figure 3 or 

4,

3. Rock the Battery into the printer as shown until it locks in 

place.

When the battery is first installed, the Control Panel indica-

tors may briefly turn on and then go off, indicating the battery 

is not fully charged (see “Charging the Battery” below and 

“Operator Controls.”)

Charging the Battery

The LI72 is a wall mounted fast charger with universal 110 

to 230, 50-60 Hz. VAC input. Multiple A.C. plug configurations 

comply with most international standards.   This charger is in-

tended for use with the RW series printers which are equipped 

with Lithium Ion (Li-Ion) batteries.

continued

Figure 5: LI 72 Single Charger

LI72 Charger

For best results, 

remove the 

Battery Pack while 

charging.

Charger Jack