Zebra Rw 220 User Manual - 0336

33

RW Series User Guide

Compact Flash (802.11b) Radio Module

The following section only applies when the CF (Compact Flash) WLAN module (With 

FCC ID:  I28MD-RW4137) is installed in a RW series printer. The FCC ID number is on the serial number 

label on the back of the printer and can be read with the module installed. Other than conditions specified 

elsewhere in this manual, only one of the radio options can be installed in the printer at one time and the 

antenna used for this transmitter must not be co-located or must not operate in conjunction with any other 

antenna.

Caution • Use of a RW series printer with the radio module marked 

with “FCC ID: I28MD-RW4137” meets the FCC requirements for 

radio frequency (RF) radiation exposure in the standard body worn 

configuration with no minimum separation. In this configuration, which 

applies whether the belt clip or shoulder strap is used, the face of the 

printer from which paper is transported is facing away from the user’s 

body. The standard configuration must always be used when the printer 

is body worn.

RW 220  printers with this radio option have been SAR tested. The 

maximum SAR value measured for each model was 0.011527 W/g 

averaged over 1 gram.

RW 420  printers with this radio option have been SAR tested. The 

maximum SAR value measured for each model was 0.062 W/kg 

averaged over 1 gram.

European Regulatory Information for this Radio

AT

BE

CY

CZ

DK

EE

FI

FR

DE

GR

HU

IE

IT

LV

LT

LU

MT

NL

PL

PT

SK

SI

ES

SE

GB

Note: -Member states in the EU with restrictive use for this device are  

crossed out!

This device is also authorized for use in all EFTA member states (

CH, IS, LI, NO)

0336

Important Notice:

This device is a portable RF printer intended 

for commercial and industrial usein all EU and 

EFTA member states except in France where 

restrictive use applies.

continued