Zebra Rw 220 User Manual - Modules

39

RW Series User Guide

Compact Flash (802.11b) and Bluetooth Co-located Radio 

Modules

The following section only applies when the CF (Compact Flash) WLAN module (With 

FCC ID: I28MD-RW4137) and Bluetooth module (FCC ID: I28MD-BTC2TY3) are installed in a RW 420 printer. 

This co-located radio configuration has demonstrated compliance to FCC regulations.  The FCC ID numbers 

are on the serial number label on the back of the printer and can be read with the module installed.

  Caution • Use of a RW 420 printer with the radio module marked 

with both “FCC ID: I28MD-RW4137” and “I28MD-BTC2TY3” meets the 

FCC requirements for radio frequency (RF) radiation exposure in the 

standard body worn configuration with no minimum separation. In this 

configuration, which applies whether the belt clip or shoulder strap is 

used, the face of the printer from which paper is transported is facing 

away from the user’s body. The standard configuration must always be 

used when the printer is body worn.  RW 420 printers with this radio 

option have been SAR tested. The maximum SAR value measured for 

each model was 0.28 W/kg averaged over 1 gram.

European Regulatory Information for the Compact Flash 802.11b 

Radio and Bluetooth Co-located Radio Modules

AT

BE

CY

CZ

DK

EE

FI

FR

DE

GR

HU

IE

IT

LV

LT

LU

MT

NL

PL

PT

SK

SI

ES

SE

GB

Note: -Member states in the EU with restrictive use for this device are  

crossed out!

This device is also authorized for use in all EFTA member states (

CH, IS, LI, NO)

Europe – EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive 

1999/5/EC. The following test methods have been applied in order to prove 

presumption of compliance with the R&TTE Directive 1999/5/EC:

• EN 60950: 2000

Safety of Information Technology Equipment

• EN 300 328-2 V1.2.1 (2001-12)

Technical requirements for spread-spectrum radio equipment

• EN 301 489-17 V1.2.1 (2002-08)

EMC requirements for spread-spectrum radio equipment.

This device is a 2.4 GHz wireless LAN transceiver, intended for indoor home and 

office use in all EU and EFTA member states, except in France where restrictive 

use applies.

Important Notice:

This device is a portable RF printer intended 

for commercial and industrial usein all EU and 

EFTA member states except in France where 

restrictive use applies.

continued