Zebra Rw 220 User Manual - page 37

37

RW Series User Guide

WLAN Module Using 802.11b/g Radio 

The following section only applies when the 802.11b/g WLAN module (With FCC ID:  I28MD-ZLAN11G) is 

installed in a RW series printer). Other than conditions specified elsewhere in this manual, only one of the 

radio options can be installed in the printer at one time and the antenna used for these transmitters must not 

be co-located or must not operate in conjunction with any other antenna.

RW Series models have the FCC ID number on a label on the back of the unit.

   Caution • Use of a RW series printer with the radio module marked 

with FCC ID: I28MD-ZLAN11G meets the FCC requirements for 

radio frequency (RF) radiation exposure in the standard body worn 

configuration with no minimum separation. In this configuration, which 

applies whether the belt clip or shoulder strap is used, the face of the 

printer from which paper is transported is facing away from the user’s 

body. The standard configuration must always be used when the printer 

is body worn.

The RW 220 and RW 420 printers with this radio option have 

been SAR tested. The maximum SAR value measured for 

each model is listed below:

Model

SAR value W/Kg (1g average)

)

RW220

0.004 

RW 420

0.004 

European Regulatory Information for this Radio

AT

BE

CY

CZ

DK

EE

FI

FR

DE

GR

HU

IE

IT

LV

LT

LU

MT

NL

PL

PT

SK

SI

ES

SE

GB

Note: -Member states in the EU with restrictive use for this device are  

crossed out!

This device is also authorized for use in all EFTA member states (

CH, IS, LI, NO)

Important Notice:

This device is a portable RF printer intended 

for commercial and industrial usein all EU and 

EFTA member states except in France where 

restrictive use applies.

continued