3Com VCX V7000 Telephone Manual - page 40

40

C

HAPTER

 3: B

ASIC

 T

ELEPHONE

 O

PERATION

If the VCX system or the phone reboots or is upgraded with new 

software, the ringer resets to the default ringer enabled (feature disabled) 

mode.

To mute the phone ringer: 

1 Press Feature + 489. The LCD displays:

Ringer is now muted.

2 To clear the display, press the Clear softbutton. The next time you receive 

an incoming call, the ringer is muted.

3 To turn this feature off, press Feature + 489 again. The LCD displays:

Ringer is now enabled.

4 To clear the display, press the Clear softbutton.

Activating Do Not 

Disturb 

When you enable Do Not Disturb, incoming calls immediately go to the 

call coverage point set by you or your administrator. The default call 

coverage point is your voice mailbox. The call coverage point is set 

through the VCX User Interface (see 

Chapter 6

).

When your telephone is in Do Not Disturb mode:

■

An incoming call does not cause your phone to ring. If you are logged 

in to multiple phones using the same phone number and one of the 

phones enables Do Not Disturb, the feature applies to all phones—an 

incoming call will not ring on any of the phones.

■

You can use the phone to dial outgoing calls.

■

If you enable Do Not Disturb while one or more calls are ringing, the 

pending calls are sent to your call coverage point and Do Not Disturb 

is enabled for all subsequent calls.

■

If you are a Hunt Group member and you enable Do Not Disturb, 

personal (non-Hunt Group) calls go to your call coverage point. 

However, Hunt Group calls always ring on a member’s phone, 

regardless of the Do Not Disturb setting.

If your telephone is part of a bridged extension, see 

Do Not Disturb and 

Bridged Line Calls

 for additional information.