ABB LS4000 Operating Instructions Manual - page 127
LS4000, LS4060 DIODE LASER ANALYZERS | OI/LS4000/O2-EN REV. A
127
Fitting the cable clips and line brackets
The cable clips and line brackets must meet the following conditions:
They must allow the cables and lines to be laid securely.
It must be possible to open the cable clips and line brackets to allow the
cables and lines to be removed temporarily for calibration of a separate
calibration set or for servicing.
Fit the cable clips and line brackets along the defined cable and line runs.
Important notes on laying the cables and lines
All cables must be installed securely.
If there is a danger of explosion due to dust, precautionary measures must
be taken to prevent the development of static charges on the surface of
cables and leads.
Requirements for
cable clips and line
brackets
Fitting the cable clips
and line brackets
Important notes