Anthem AVM 20 Setup Menu - 7. Setup Menu
53
Procedure for Setting Bass Peak Level:
• Enter the Setup (section 7.1). Go to ‘6. SPEAKER LVL CALIBRATION’ and press SELECT.
• Press the
' button until you reach “6k. SET BASS PEAK LEVEL” and press SELECT.
• Press the
' button until you reach “b. ADJUST LEVEL: –50.0 dB”.
• A test signal should be audible. Use the
"# buttons to turn up the level of the test signal until
distortion from the subwoofer (or ‘Large’ L/R Fronts if Subwoofer is set to ‘No’ – see section 7.4.4)
begins to appear, then lower the level of the test signal until the distortion just disappears. At this
point the sound may be surprisingly loud even though it’s not distorted – make sure that you do not
stop at a setting that is too low, or very little bass may be heard during movie or music playback.
• Press the
' button to go to “c. SET NEW PEAK LEVEL”.
• Use the
"# buttons to change to “Yes”.
• Press SELECT. The AVM 20 will not allow bass output to exceed the new setting.
• Press BACK to leave the submenu.
7.4.7 VOLUMES
This menu allows you to define the power-on volume settings.
Power-On Volume:
Whenever you turn MAIN, ZONE2, or ZONE3 on, all conditions remain the same as when they were last
turned off, except Volumes. This avoids any potential ‘surprises’ of not knowing what volume someone had
set when they last turned MAIN, ZONE2, or ZONE3 off, and then having the power-on volume be either too
loud or quiet. You can set independent volumes for MAIN-ON, ZONE2-ON, ZONE3-ON, and HEADPHONE-ON.
Then when you turn MAIN, ZONE2, or ZONE3 on, or plug in your headphones, the volume for each will come
on at the known levels you have set.
Maximum Volume:
These settings allow you to individually limit the volume of MAIN, ZONE2, ZONE3, or HEADPHONE to avoid
damaging your equipment and/or your ears. This can also serve as a parental volume control feature. The
range of settings available for MAIN is from –95.5 dB to +31.5 dB in steps of .5 dB, and for ZONE2, ZONE3,
and HEADPHONE, the range is from –70.0 dB to +10.0 dB in 1.25 dB steps.
Volume Speed:
This sets how quickly the volume changes for each ‘turn-of-the-knob’ or press of the Remote Control volume
keys. Choose either ‘Slow’ or ‘Fast’.
7. SETUP MENU
continued …
7. VOLUMES
a.
MAIN ON VOLUME : –35.0 dB
b.
MAIN MAX VOLUME : +10.0 dB
c.
ZONE2 ON VOL : –35.0 dB
d.
ZONE2 MAX VOL :
+0.0 dB
c.
ZONE3 ON VOL : –35.0 dB
d.
ZONE3 MAX VOL :
+0.0 dB
e.
HPHONE ON VOL : –20.0 dB
f.
HPHONE MAX VOL : +10.0 dB
g.
VOLUME SPEED : Fast